use RX to monitor transmitter.

General discussion and support for the Peaberry SDR V2.

use RX to monitor transmitter.

Postby N2TOH » Wed Jun 24, 2015 8:25 pm

I was just thinking of ways to eliminate undesired signals from a power amplifier, and then recalled the practice of generating per-distortion that was once used to drive tube amplifiers in some Bell Systems Microwave links.

I hypothesize the same could be done with the Peaberry by using the receiver to monitor the transmitted signal in full-duplex mode.
N2TOH
 
Posts: 68
Joined: Sat Oct 12, 2013 12:55 pm

Return to Peaberry SDR V2

Who is online

Users browsing this forum: No registered users and 5 guests

cron