Page 1 of 1

Use with Vitual Audio Cable

PostPosted: Thu Mar 19, 2015 7:44 am
by tannebri
First of all I really like the program.

But I cannot get the program to run with a VAC. The VAC prgram runs with other program like HDSDR and GSDR but not with this program.The audio output via VAC is very raspy and unintelligible. Can anyone help.

Brian

Re: Use with Vitual Audio Cable

PostPosted: Thu Mar 19, 2015 9:12 am
by AE9RB
The author of VAC didn't release any source code. Peaberry CW is open source. Perhaps the VAC author can help since he's not solving a black-box problem.

Or you can try a different approach. Describe what it is you're trying to do and maybe someone can help you find a solution that doesn't need VAC.

Re: Use with Vitual Audio Cable

PostPosted: Thu Mar 19, 2015 10:54 am
by tannebri
Okay

I'm trying to connect the o/p of the peaberry via a VAC to a morse decoder program in this case the MRP40. It is so I can leave it running in the house without the Audio annoying the XYL I can come back a glance at it to see who is/was on the QRP frequency.

What I do is set the bandwidth to 1Khz then let the AFC in MRP40 do the rest.

Brian

Re: Use with Vitual Audio Cable

PostPosted: Thu Mar 19, 2015 1:08 pm
by kz1x
Since you aren't transmitting, why don't you just use HDSDR (in CW mode) and the VAC to feed the decoder?

Re: Use with Vitual Audio Cable

PostPosted: Thu Mar 19, 2015 4:30 pm
by tannebri
Hi

I have never managed to get CW to work using HDSDR its fine with SSB etc. I will go back and have another look at HDSDR. But I just rally like the neat simple layout of this software and it works on CW.

Brian