Page 1 of 1

Only "Dah" paddle is producing sound, "Dit" paddle is not re

PostPosted: Sun Feb 21, 2016 7:18 am
by Rob
My iambic has been working flawlessly for a month. Tried it tonight and the Dah paddle works fine, but Dit paddle is not producing anything, sound or LCD characters. Have ohm'ed out the paddle and connector cable and all is good. Any suggestion as to a board component to check?

Re: Only "Dah" paddle is producing sound, "Dit" paddle is no

PostPosted: Sun Feb 21, 2016 4:22 pm
by Rob
Forget this post. I found the fault in the paddle contact on the Dit side.