Page 1 of 1

New V2 working fine - need enclosure

PostPosted: Wed Jun 17, 2015 3:46 pm
by k1qn
This is my second one, and it went together with virtually no problems. I want to put it in the Acrylic Case, but none are available. Any suggestions for a temporary (and simple) basing method? Right now, it's folded up in the last page of instructions, leaving plenty of room for the heat sink to breathe.

BTW, anyone want the left over parts from a 60/40/30/20 build?

Contact directly alpg49@gmail.com.