New V2 working fine - need enclosure

General discussion and support for the Peaberry SDR V2.

New V2 working fine - need enclosure

Postby k1qn » Wed Jun 17, 2015 3:46 pm

This is my second one, and it went together with virtually no problems. I want to put it in the Acrylic Case, but none are available. Any suggestions for a temporary (and simple) basing method? Right now, it's folded up in the last page of instructions, leaving plenty of room for the heat sink to breathe.

BTW, anyone want the left over parts from a 60/40/30/20 build?

Contact directly
Al Gerheim, K1QN
Celebrating 50 years in ham radio!
Posts: 90
Joined: Sun Oct 20, 2013 9:42 pm

Return to Peaberry SDR V2

Who is online

Users browsing this forum: No registered users and 4 guests