transformer pinout

General discussion and support for the Peaberry SDR V1.

transformer pinout

Postby w8kfj » Mon Dec 31, 2012 12:04 am

I installed t2, and assumed that since there was a bar silk screened at one end, I would start counting clockwise from the bottom at that end (like a chip). I now see a trace on the bottom between two points. This must be 4 and 5 (numbers from the schematic), since they are the only two connected together. I must be wrong. Apparently I missed some information.
Posts: 4
Joined: Sat Dec 29, 2012 5:00 pm

Re: transformer pinout

Postby Ve7pke » Mon Dec 31, 2012 12:48 am

Transformer goes like this. The ensemble doc have lot of detail.
The two pins with the bar is where the primary goes.
The first secondary then goes in the next two pins beside the line.
The second secondary goes in the next two pins.

I hope that helps.
Posts: 15
Joined: Fri Nov 30, 2012 7:30 am

Return to Peaberry SDR V1

Who is online

Users browsing this forum: No registered users and 1 guest