Page 1 of 1

CW by keying external audio tone generator

PostPosted: Fri Apr 04, 2014 12:27 am
by VE3LC
It seems to me trying to use PwrSDR with the Peaberry for CW is messy.

However, keying an external low THD audio oscillator and using it to modulate the Peaberry V2 in USB mode should work well using HDSDR. And since you can custom set the RX (and TX) bandwidth, then the receive window can be readily placed where the TX CW frequency would be with mod frequency of 1.5 kHz.

I also note that the software, CWType software may also be a solution to generating the CW modulation. http://www.dxsoft.com/en/products/cwtype/

So anybody considered these options for CW with the V2?

I will be experimenting and report further.

Norm, VE3LC
Ottawa, ON Canada

Re: CW by keying external audio tone generator

PostPosted: Fri Apr 04, 2014 1:37 am
by VE3LC
Sorry.. error in posting. This posting was meant for the Peaberry V2 forum.. It is repeated there..

Norm, VE3LC